In this lab experience, students are challenged to design an electronic motor. Students observe that care needs to be taken for a smooth consistent spin.
Safety:Before conducting the lab, review the safety precautions on the student page with the class. Discuss any safety precautions that are specific to your science laboratory or classroom.
Materials Included in Kit:
Consumable: Copper wire, 16 gauge, 8 ft Magnet wire, 22 gauge, 125 ft
Non-Consumable: Ceramic ring magnets, 30
Connector cords w/ alligator clips, 20 Foam block, 6” x 12” x 1”, 2
Additional Materials Required: Battery, 9-V
Meter stick
Pliers, needle-nose with wire cutters
Sandpaper strip
Scissors, or paper cutter
Tube or rod, approximately 2 cm in diameter
1-800-452-1261
